You can see the 3D modeling panel in your home ribbon tab.
Menu browser> tools> work spaces> 3D modeling Steps Involved in Revolve for AutoCAD 2009Īs you know that in AutoCAD you cannot sketch sections in any 3D commands, so get your section ready before hitting the revolve command. On an average for AutoCAD 2009 you can start all axisymmetric models with revolve.
#AUTOCAD 2009 3D COMMANDS SOFTWARE#
Whether to use revolve for a model or not that depends entirely upon the geometry and the software you use.
#AUTOCAD 2009 3D COMMANDS PRO#
In pro engineer and other 3D software, you have a command called pattern, which is used quite extensively with revolve to get the final model quickly. Like, you have to model the wheel of a bull cart, for doing this you may have to go for additional cut operations after using revolve. Some time you may come across with the objects which are not fully axisymmetric. In other words, axisymmetric objects are created by arranging infinite number of slices around the axis and all the slices are identical.įor all axisymmetric model you can use revolve command. Take the example of the cylinder, if you create a rectangular section and revolve it aroundĪ axis, you will get the cylinder. These objects will have an axis and by rotating a section around this axis could generate the object itself. The objects like cylinder, pulley, ball etc are said to be axisymmetric. In revolve, the whole shaft could be created in a single command however for creating the same using extrude you may be required to use more than two commands. But it is always recommended that you use revolve instead of extrude in such cases because revolve takes much lesser time. For example, a stepped shaft (means a shaft with different diameters at different sections) could be modeled using both the command. If you are using AutoCAD 2009 or any other 3D software, you may have noticed that some of the geometry could be created using both extrude as well as revolve.
0 kommentar(er)
